[Subject Prev][Subject Next][Thread Prev][Thread Next][Subject Index][Thread Index]

[vine-users:08396] 2.2.10化に成功したけど


こんばんわ

先程、カーネルを2.2.10化に成功しました。
取り敢えずは動いてるのですがサウンド出力レベルが下がってしまいました。
何が原因でそうなってしまうかは判りませんがとにかく、うごいてます。
以下にdmesg結果を入れておきます

--- dmesg for kernel-2.2.10 ---
Linux version 2.2.10 (root@kurasawa.linux.net) (gcc version 2.7.2.3) #6 SMP Sat Jul 3 20:32:21 JST 1999
mapped APIC to ffffe000 (00235000)
mapped IOAPIC to ffffd000 (00236000)
Detected 400917037 Hz processor.
ide_setup: hdc=ide-scsi
Console: colour VGA+ 80x25
Calibrating delay loop... 399.77 BogoMIPS
Memory: 387700k/393216k available (916k kernel code, 416k reserved, 4136k data, 48k init)
VFS: Diskquotas version dquot_6.4.0 initialized
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.35 (19990512) Richard Gooch (rgooch@atnf.csiro.au)
per-CPU timeslice cutoff: 100.22 usecs.
CPU0: Intel Pentium II (Deschutes) stepping 02
SMP motherboard not detected. Using dummy APIC emulation.
PCI: PCI BIOS revision 2.10 entry at 0xfb420
PCI: Using configuration type 1
PCI: Probing PCI hardware
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
Starting kswapd v 1.5 
Detected PS/2 Mouse Port.
pty: 256 Unix98 ptys configured
Real Time Clock Driver v1.09
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:DMA
    ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:DMA
hda: ST36422A, ATA DISK drive
hdb: CD-ROM 40X/AKU, ATAPI CDROM drive
hdc: YAMAHA CRW2216E, ATAPI CDROM drive
hdd: ST38420A, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: ST36422A, 6103MB w/256kB Cache, CHS=778/255/63, UDMA
hdd: ST38420A, 8223MB w/512kB Cache, CHS=16708/16/63, UDMA
hdb: ATAPI 40X CD-ROM drive, 128kB Cache
Uniform CDROM driver Revision: 2.55
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
md driver 0.36.6 MAX_MD_DEV=4, MAX_REAL=8
Partition check:
 hda: hda1 hda2 < hda5 hda6 >
 hdd: [PTBL] [1048/255/63] hdd1
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 48k freed
Adding Swap: 128484k swap-space (priority -1)
es1370: version v0.22 time 20:34:08 Jul  3 1999
es1370: found adapter at io 0x9400 irq 11
es1370: features: joystick off, line in, mic impedance 0
tulip.c:v0.89H 5/23/98 becker@cesdis.gsfc.nasa.gov
eth0: Digital DS21142/3 Tulip at 0x9800, 00 c0 ca 11 1c 47, IRQ 10.
eth0:  EEPROM default media type Autosense.
eth0:  Index #0 - Media 10baseT (#0) described by a 21142 Serial PHY (2) block.
eth0:  Index #1 - Media 10baseT-FD (#4) described by a 21142 Serial PHY (2) block.
eth0:  Index #2 - Media 100baseTx (#3) described by a 21143 SYM PHY (4) block.
eth0:  Index #3 - Media 100baseTx-FD (#5) described by a 21143 SYM PHY (4) block.

--- end ---
---
倉沢 佳樹


この情報があなたの探していたものかどうか選択してください。
yes/まさにこれだ!   no/違うなぁ   part/一部見つかった   try/これで試してみる

あなたが探していた情報はどのようなことか、ご自由に記入下さい。特に「まさにこれだ!」と言う場合は記入をお願いします。
例:「複数のマシンからCATV経由でipmasqueradeを利用してWebを参照したい場合の設定について」
Follow-Ups: